Wednesday, July 20, 2011

Water Gun Holster Tutorial

In case you missed it over on Living With Punks, I thought I'd re-post this tutorial here, especially since we are in the midst of an insane heat wave here in Ohio. Anyone else wake up feeling like they were in the Amazon?

Whip up a few of these holsters to help your kiddos beat the heat. Because the heat is insane. Have I mentioned that it's hot?

Anywho, here we go!


To make this project, you'll need:

Velcro
Sewing machine
Thread
Several long scraps of fabric



A word about scrap sizes - At least one of your fabric scraps should be long enough to wrap around your child's waist with a few inches of overlap. The other scraps should be large enough to wrap around your water guns with a little overlap. Water guns vary greatly in size, so check to make sure your scraps are large enough before sewing. I used individual pieces of fabric, but obviously you could piece this project together with smaller scraps as well. 

I happen to have a roll of Velcro from an abandoned project, so I used lots. LOTS. If you don't have a ton of Velcro laying around, you could use much less than I did by applying the Velcro only at the belt closure and where the water gun will attach, as opposed to all the way around the belt. 

Cut your strips at least twice as wide as your Velcro. I applied two strips of 3/4 inch Velcro, and I wanted some space in between, so my belt strip is approximately five inches wide. The strips for the water gun attachment is maybe 4 inches wide. 




Press the ends of your strips towards the wrong side (approximately half an inch). Fold your strips in half, right sides together, and stitch the open edge closed. Using a bodkin or a safety pin, turn your strips right side out and press flat. 


Now apply your Velcro. I stitched two strips of Velcro to the entire length of the outside of the belt. I put the "soft" part of the Velcro on the outside of the belt. Then, I stitched about 6 inches of the "hook" portion of the Velcro to the inside of the belt, as the belt closure.

On the strip that attaches to the water gun, I did exactly the opposite, with the hook Velcro along the length of  the outside of the strip, and the soft, loop part on the inside of the strip as the closure.


Once the Velcro is applied, wrap it around your water gun.


And wrap the belt around your kiddo.

Stick the water gun to the belt...


And prepare for a water fight!

(Yes, his shirt IS inside out and backwards. :) Don't judge.)

But this kid better watch out, because mama has the hose, and I fight back!


So, what do you think? Riley thought it was awesome. It's amazing - my kids seem to appreciate the simplest projects far more than the complicated, time-consuming ones! 

I've also discovered that you can use this holster for basically ANY toy - not just water guns. I love a project that can be used again and again for different purposes.






2 comments:

  1. bersa thunder 380 holster
    - Welcome to DeSantisHolster.com, your online source for the finest Concealment Holsters, Inside the Waistband Holsters and Gun Holsters for every major weapon manufacturer and model.

    ReplyDelete

I love to hear what you have to say! I try to respond to as many comments as possible, mostly via email. If you have a question and your email address is not attached to your google profile, I will respond here in the comments.

Related Posts Plugin for WordPress, Blogger...